The Challenges to Swim Spa Covers

Swim Spas represent unique obstacles when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub needs a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot more difficult.
Getting a new swim spa is an exciting event in life. You’re looking forward to the workout you’ll obtain from using it. Possibly you’re a little relieved to have actually lastly selected from the different models you looked at. At any rate, you most likely weren’t believing much about the cover you would use.
Normally, the cover that comes home with your brand-new purchase will be a 4 area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence due to the fact that as soon as it is placed in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are very little as they increase from the water surface. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It happens slowly and on a Swim Spa Cover which is made of specific sections, at differing speeds. So ultimately you’ll discover one or two of the areas are truly getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance because you still need to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a different design for their Swim Spa Covers
Instead of using several foam panels to develop Swim Spa Covers that will eventually end up in some landfill, they designed one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or break down at the seams either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the cover for it.
If you’re not prepared to buy today, bookmark this site so you can discover it once again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *